Seriously, couldn’t they just extend the tube a bit so it overhangs the exhaust pipe???

  • TweetyDaBird@lemmy.world
    link
    fedilink
    English
    arrow-up
    26
    arrow-down
    5
    ·
    1 year ago

    No, this is not asshole design. If the oil port was sticking further out, it’s gets knocked off if you lay the bike down. And then you have no oil at all, and a blown up motor.

    It’s by good design the oil port is recessed. Yes it’s annoying to use a funnel, but it’s the preferable option.

    • Pyr_Pressure@lemmy.ca
      link
      fedilink
      English
      arrow-up
      6
      arrow-down
      1
      ·
      1 year ago

      ?? Oil port would only need to be extended by like 0.5" to clear that exhaust pipe, the casing to the left extends probably 1-2" from that. If you lay the bike down it that casing would stop the oil port from being touched. Shouldn’t be an issue.

      • TweetyDaBird@lemmy.world
        link
        fedilink
        English
        arrow-up
        3
        ·
        1 year ago

        And the cap on the port extends another .5-1” when in place. Which means it’s sitting below the surface of the other things as is, but add .5” and it now becomes level with a few things. And level is by far enough for the cap to grab, twist and pull out. And when it does, you’re done riding for a while.

        And instead of replacing the tip of the oil cap and the outer cases, you end up with a damaged block. Much more expensive.

        A far better idea is to have a tool, admittedly not in every man’s possession, but tilt the bike away, remove the cap, and thread in. Tilt the bike back and you have a little spout. Clean, simple and easy. These are available for just about every manufacturers cap size and thread.