The .stl and .fcstd files are at the link. All the test joints I printed fit together really nicely, but I’m worried the overall design might have issues that I’m too much of an amateur to identify. It’ll need a LOT of filament… Good wooden marudai cost hundreds of dollars, whereas 1500g of my preferred filament is only like $45, but I’d still hate to waste that much of it. The printing itself I’m not too concerned about, it’s easy stuff. Just a little bridging and no support. Of course, that doesn’t necessarily mean the finished/assembled object will be functional. Thanks in advance if you have any tips!
PS: This is also my first use of the spreadsheet function, I usually just rely on named constraints from prior sketches. It’s really neat. FreeCAD rules!
Only magnets, actually. The design is similar to yours; a top plate, four legs and a base.
I drilled four holes in the base and the top, holes in either end of the legs, glued neodymium magnets in all the holes (be sure to get the polarity right :) ). The whole setup is loose and can wobble a bit, but not enough to actually impede usage.
Wow that’s amazing! Maybe I should incorporate some holes for magnets into this, just in case the existing fit isn’t enough.